Multirotors * | Happymodel X12 1-2S Brushless Aio Flight Controller Frsky

5-In-1 Aio Flight Controller Using Openvtx (Up To 400Mw), 12A Esc (Blheli_S Esc), Onboard Frsky Receiver (D8/D16), Plugin Connector For Your Motors And Can Take 1S Or 2S Batteries.

Notes: Do Not Flash The Board With 4.3.1. There Are Spi Related Issues When Using 4.3.1. A Fix Is Coming With A New Firmware That Will Be Available Soon (4.3.2). Stay On 4.3.0 Or Below.

Although D8 Is Still Recomended, If Using Bf 4.3.0, You Can Now Use D16 As Well.

Notes: This Is The V2 Version Capable Of Taking Up To 2S.

Specifications:

Fc:

Betaflight Firmware Target: Crazybeef4Fr

Mcu:Stm32F411Ceu6 (100Mhz, 512K Flash)

Sensor: Icm42688P

Mount Hole Size: 25.5Mm*25.5Mm

Power Supply: 1-2S Battery Input (Dc 2.9V-8.7V)

Built-In 12A (Each) Blheli_S 4In1 Esc

Built-In Betaflight Osd (Spi Control)

Built-In 5.8G Openvtx 0Mw~400Mw

Built-In Frsky D8/D16 Rx

Built-In Voltage Meter Sensor: Voltage Meter Scale 110

Built-In Current Meter Sensor: Current Meter Scale 470

Weight: 5.1G

4In1 Esc:

Power Supply: 1-2S Lipo/Lipo Hv

Current: 12A Continuous Peak 15A (3 Seconds)

Supports Blhelisuite

Factory Firmware: Z_H_30_Rev16_7.Hex

Default Protocol: Dshot300

Supports Bluejay Firmware

When Using Bluejay Firmware With 48Khz, Set Startup Power To 1100/1200

Receiver:

Spi Bus Receiver

Cc2500 Rf

Compatible With Non Eu Transmitter D8 Model Channels: 8Ch

No Ground Interference ( Transmitter And Receiver 1 M From The Ground):
200Meter Failsafe Supported

Supports Frsky D8/ D16 , Redpine , Sfhss

Openvtx:

Firmware Version: Openvtx

Smartaudio V2.1

Pit Mode Supported

Race Mode Supported

Channels: 48Ch

Transmitting Power: 0/Race/25Mw/100Mw/400Mw

Power Supply: Dc 5V

Current (5V): 650Ma (400Mw)

Antenna Connector: U.Fl

Package:

1X X12 Aio Board

1X Dipole Ufl Antenna

1X Camera Cable

1X Ph2.0 Pigtail

1X Set Of Screws And Grommets

Wiring Diagram Here