Multirotors * | Happymodel Larva X Crazybee F4 Pro V3 2-4S Flight Controller Frsky

Specs:

(Frsky Version) Crazybee F4Fr Pro V3.0 Firmware Target: Crazybeef4Fr

Mcu:Stm32F411Ceu6 (100Mhz, 512K Flash)

Sensor: Mpu-6000(Spi Connection)

Board Size: 28.5 * 28.5Mm

Power Supply: 2-4S Battery Input (Dc 7-17V)

Built-In 10A(Each) Blheli_S 4In1 Esc Dshot600 Ready

Frsky Version Built-In Spi Frsky Receiver With Telemetry(D8/D16 Switchable)

Built-In Betaflight Osd(Spi Control)

Built-In Current Meter Max 70A

Current Meter Scale Set To 470

Built-In 5V 1A Bec

Built-In Voltage Detection

Mcu Upgraded To Efm8Bb21

Power Supply: 2-4S Lipo/Lipo Hv (7V/17V)

Current: 10A Continuous Peak 12A (5 Seconds)

Support Blhelisuite Programmable

Factory Firmware: F_H_40_Rev16_5.Hex

Default Protocol: Dshot600

Spi Bus Receiver

Frsky D8/D16 Switchable

Compatible Non Eu Transmitter Both D8 And D16 Mode

Channels: 8Ch Or 16Ch

Failsafe Support

No Ground Interference ( Transmitter And Receiver 1 M From The Ground): 300M

Spi Bus Receiver

Protocol: Afhds And Afhds-2A Switchable

Channels: 8Ch(Afhds) Or 14Ch(Afhds-2A)

No Ground Interference ( Transmitter And Receiver 1 M From The Ground): 300M

Failsafe Support

Recommend Battery: 2S 450Mah/550Mah , 3S 300Mah/350Mah/450Mah, 4S 300Mah/350Mah

Notes: If Used 3Inch Propellers, We Recommend Use 2-3S Only