Crazyf411 Pro Is A Highly Packed 6.3G 2-4S Aio F4 Flight Controller With Built In 20/25A Per Channel Esc And Diversity Receiver.
Low Latency D8/D16 Futaba S-Fhss Redpine Protocol With Dual Ipex Ufl Antenna (With Power Amplifier)
Large Soldering Pads With 4 Angled Motor Connector (Not Soldered)
2 Complete Uart (Uart 1 With Inverted Px Pad)
Compatible With 110X/120X/130X/140X Motors
Integrated With F411 Processor, Betaflight Osd, 5V 1.5A Bec
Flight Controller
Mcu:Stm32F411Ceu6 (100Mhz, 512K Flash)
Sensor: Mpu-6000(Spi Connection)
Board Size: 28.5 * 28.5Mm
Power Supply: 2-4S Battery Input (Dc 8V-17V)
Built-In 20A(Each) Blheli_S 4In1 Esc Dshot600 Ready
Built-In Frsky D8/D16 Spi Receiverbuilt-In 2.4G Power Amplification
Built-In Betaflight Osd(Spi Control)
Built-In Current Meter
Built-In 5V 1.5A Bec
Built-In Voltage Detection
Firmware Target: Matekf411Rx
Yaw Degrees Should Set To “-90 Degree” To Match The Flight Direction
Onboard 4In1 Esc
Mcu Upgraded To Efm8Bb21
Power Supply: 2-4S Lipo/Lipo Hv (7V/17V)
Current: 20A Continuous Peak 25A (5 Seconds)
Support Blhelisuite Programmable
Factory Firmware: F_H_40_Rev16_7.Hex
Default Protocol: Dshot600
Bind Procedure:
1.Make The On Board Receiver Get Into Bind Mode: For 4.0.X Version Firmware Plug Usb And Then Connect Betaflight Configurator And Then Move To Cli Tab , Type “Bind_Rx_Spi” ,The Red Led On The Top Of The Flight Controller Will Getting To Be Solid , The Onboard Receiver Is In Bind Mode; For 4.1.X Or 4.2.X The Bind Code Is “Bind_Rx”
2. Make Your Transmitter Get Into Bind Mode . If Bind Is Successful The Red Led Will Starting To Blink. The Red Led Wouldn’T Blinking When Binding With Some New Access Firmware Frsky Radio , But The Bind Is Actual Successful , Need To Go To Cli Command And Type “Save” To Finish The Binding .
Spi Receiver Option All Selectable In Betaflight
Frsky_D Compatible With Frsky D8 Protocol
Frsky_X Compatible With Frsky Non-Eu D16 Protocol
Frsky_X_Lbt Compatible With Frsky Eu-Lbt D16 Protocol (4.0.X Or Latest Betaflight Firmware Support)
Sfhss Compatible With Futaba S-Fhss Protocol
Reviews
There are no reviews yet.